TYPE
Two-component epoxy polyamide floor finish
USES
Interior cement and concrete floors
FEATURES
Long-lasting and excellent adhesion and Ideal abrasion and impact resistance Resistance to most of the chemicals
APPLICATION DATA METHOD
Roller, Brush, Spray
THEORETICAL COVERAGE: 9 – 11 Sq.m/liter at wet film thickness 60 – 70 micron. The actual coverage will depend on the surface texture
DRY FILM THICKNESS: 35 – 40 micron
SURFACE PREPARATION NEW FLOORS
The surface must be free of wax polish, oil, dust, grease & sand. Remove wax or polish by scrubbing vigorously with Turpentine. Wash with a liquid detergent to remove grease and oil. Wash with clean water to remove any leftover detergent on newly laid floors. Remove all traces of the remaining detergent by washing many times with clean water. For best results on smooth unpainted cement floors, flood with a dilute solution of Nippon Etching Solution (1 part Nippon Etching Solution to 5 parts water) and allow soaking for 20 to 30 minutes. Wash the floor with plenty of water to remove excess acid.
PREVIOUSLY COATED FLOORS
Remove any peeling or degraded paint by sanding or using a paint stripper ? Nippon Nax Ultima Paint Remover. For intact paint, thoroughly clean the surface with a strong detergent and then, lightly sand to remove gloss, if any. NOTE: Do not paint during rainy weather or wet and humid conditions. Slight traces of moisture could prevent adhesion. The moisture content should be below 8 %
DRYING TIME
Touch dry: 1 Hour at 30C ? 2oC and RH 65 % ? 5%
Full cure: 4 days at 30C ? 2oC and RH 65 % ? 5%
Overcoat: 24 Hours at 30C ? 2oC and RH 65 % ? 5%
Pot life: 1 Hour
Normal foot traffic: 24 Hours
Reviews
There are no reviews yet.